|
1. Each transfer is completely ready to iron-on. Preheat your Iron to the proper temperature for your fabric.
|
2. Slowly pull off the protective whitebacking and discard.
|
3. Place the transfer - sticky side
down onto the garment. Make sure it is exactly where you want it to be.
|
|
4. Place the iron directly onto the
clear film. Allow it to remain in
place for at least 20 seconds before moving.
|
5. Lift straight up several times
during the application to make sure the solid part of the soleplate in on the design. Where there are steam vents there is no heat.
|
6. Allow to cool and slowly remove the adhesive film. Repress from back side of the of fabric. If any trims remain on the film, replace film and
repeat steps above.
|